1. Press and hold the A button on the transmitter for about 3s to enter pairing mode. In this case, the indicator light will flash blue quickly.
2. Press and hold the B button on the receiver for about 3s to enter pairing mode. In this case, the indicator light will flash blue quickly.
Note: It will take about 3s to pair the transmitter with the receiver after they enter pairing mode. The indicator lights of both the transmitter and the receiver will turn steady blue after they are paired.
When the indicator lights of both the transmitter and the receiver flash blue, which indicates that the devices are disconnected, pairing is required.

You are advised to use a USB sound card to reduce static noise when connecting the Lark M1 to a PC. Please do not connect the Lark M1 to the PC via the 3.5mm port directly.

Without a sound card:
● A sound card driver needs to be installed and related settings are required if the 3.5mm port of the PC is used.
● You need to select the right input device in the sound settings of the PC. Otherwise, the Lark M1 will not be used as an input microphone.
● You also need to set the microphone input in the audio settings of the live streaming software.
● There may be static noise if the 3.5mm port of the PC is used.
With a USB sound card, complicated settings are not required and there will be less static noise.

● If there is sweat or water around the device, please wipe it before putting it back into the charging case to keep the device dry.
● If the device is not in use, please keep it in a dry environment.
● If the device is not in use for an extended period, the insulating film can be taped back to the bottom.

The Lark M1 receiver has two indicators indicating the connection status of transmitter 1 and transmitter 2, respectively. If the receiver is connected with only one transmitter, one receiver indicator light will flash and then turn OFF after 1 minute.

It indicates that the receiver is in camera mode (mono mode) and is connected to only one transmitter.

Please use a USB-C to 3.5mm cable with a DAC. The original USB-C to 3.5mm cable is not supported by Honor 50 and 60.

The USB-C to 3.5mm TRS cable of the Lark M1 is an analog cable, which is not entirely applicable to all phone brands. If you are prompted that the accessory is not supported on your phone, you need to purchase an original USB-C to 3.5mm TRS cable or a cable with a DAC of the corresponding phone brands.

The Lark M1 Solo can use the Lark M1 Duo charging case for charging, but it will not turn on automatically after it is taken out of the charging case and needs to be turned on manually.