Mars 300 Pro Support

  1. Long-press the middle button of receiver to enter the menu page for checking the status of channels(“white background” indicates clean channel, “black background” indicates interference channel)
  2. Toggle up and down the wheel button on receiver to select a clean channel, then press OK button to confirm
  3. Please place the receiver at least 1.7m above the ground
  4. Please ensur that the power supply is stable

  1. Check the CAM HDMI output settings, the resolution should be set as 1080p/1080i; HDMI information Display should be OFF and HDMI control should be OFF.
  2. Check the HDMI cable, Please connect the CAM with Monitor through the HDMI cable to check whether the outputing is correct or not?
  3. Please connect transmitter with computer through HDMI cable to check whether the transmitter could display the correct video format?

  1. Please check if you have used Type-C adapter to power the device, then please change to use DC/NPF battery to power  if you have, because the charging current and voltage of Type-C adapter needs over 5V 2A
  2. Please try to restart the device
  3. If transmitter works fine, only receiver display”一”, please pair the transmitter and receiver.

Because our receiver didnt support decimal point frame output, it will automatically convert it into integer frame video ourput.

All Micro single/SLR camera, only one of  HDMI video output and camera’s screen display can be enabled  when you are recording 4K video because of the limitation of the camera itself. so you can try to set the shooting format as 1080.

But Photo-graphy/Video camera does not have this limitation, it support HDMI video output and camera’s screen dispay simultaneously.

If you insist to use Micro single/SLR camera recording 4k video and monitoring the shooting simultaneously, please connect Camera->ATOMOS Recorder->Transmitter

Because of the video format of BMD SDI input support up to P59.94, please set the video format to 1080P50/i50 on the camera side.

Please do the camera HDMI settings as below:

  1. Change HDMI output format to 1080p/i (Not recording format)
  2. Set HDMI Information Display to “OFF”
  3. Set HDMI Control to “OFF”

Actuallly the HDMI input port 1 of ATEM mini only support RGB mode and our device output is YUV format. That is why the the image turns green, its compatibiliy issue. But Port 2/3/4 of Atem could works fine.

Please keep the mobile phone at least 2m away from transmitter