Mars 4K Support

Mars 4K supports one transmitter connection to up to two receivers, so there are two signal bars on the transmitter screen. “\” will be displayed at the signal bar 2 area if the transmitter is connected to only one receiver.

  1. Press and hold the rocker-styled button on the receiver to enter the menu interface to check the status of channels (Channels in green are interference-free channels, while channels in red are channels that have interference.)
  2. Push the rocker-styled button on the receiver up or down to select an interference-free channel and then press the button to confirm the channel.
  3. Place the receiver at least 1.7 meters above the ground.
  4. Ensure that the power supply is stable.

  1. The HDMI Information Display and HDMI Control should be turned OFF.
  2. Check the HDMI cable and connect the camera to a monitor through the HDMI cable to check the output.
  3. Connect the transmitter to a computer through the HDMI cable to check whether the transmitter can display the correct video format.

  1. Check whether you are using a USB-C adapter to power up the device. If yes, then change to use a DC or NP-F battery to power up the device, because the charging current and voltage of the USB-C adapter need to be at least 5V 2.5A.
  2. Restart the device.
  3. If the transmitter is working properly, CH- will be displayed on the receiver. Please pair the transmitter and the receiver.

For micro single and SLR cameras, only either HDMI video output or camera screen display can be enabled when you are recording 4K videos. You can set the shooting format to 1080.

Photography and video cameras do not have this limitation and support both HDMI video output and camera screen display simultaneously.

If you need to use a micro single or SLR camera to record 4K videos and monitor the shooting simultaneously, please connect the camera to an Atomos recorder and the transmitter.

For some cameras such as Sony A7M3, the camera screen will be off during 4K video recording because the camera has only one video output channel during 4K video recording. Therefore, the camera screen will be off during outputting 4K videos from HDMI.

Because the SDI input video format of the Blackmagic switcher supports up to p59.94, please set the video format to 1080p50/i50 on the camera side.

Perform the camera HDMI settings as below:

  1. Set the HDMI output format to 1080p/i (not recording format).
  2. Set HDMI Information Display to OFF.
  3. Set HDMI Control to OFF.

The HDMI input port 1 of ATEM Mini only supports RGB mode, while our device output format is YUV. That is why the image turns green due to the compatibility issue. However, ports 2, 3, and 4 of ATEM Mini can work properly without this issue.

Keep the mobile phone at least 2 meters away from the transmitter.